Fujitsu ETERNUS DX8400 구성 매뉴얼 - 페이지 13

{카테고리_이름} Fujitsu ETERNUS DX8400에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8400 28 페이지. Server connection, (iscsi) for hp-ux
Fujitsu ETERNUS DX8400에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지)

페이지 인쇄

1. Hardware

Chapter 4

Checking the Server Information

The server information registered in the ETERNUS DX should be checked.

A variety of commands are used to check the following server information.

iSCSI initiator name

•

Execute the following command:

iscsiutil -l

The iSCSI initiator name is displayed in the "Initiator Name" column.

Server-side LAN card IP address for connecting to the ETERNUS DX

•

Execute the following command:

ifconfig

Set this IP address if it is not already set.

Initiator CHAP Name

•

The Initiator CHAP Name is the user name for unidirectional CHAP authentication. Execute the following

command:

This is not required if CHAP authentication is not used.

iscsiutil -pD

The Initiator CHAP Name is displayed in the "Initiator CHAP Name" column of the applicable target infor-

mation.

CHAP Secret

•

The CHAP Secret is the password for unidirectional CHAP authentication. Execute the following command:

This is not required if CHAP authentication is not used.

iscsiutil -pD

The CHAP Secret is displayed in the "CHAP Secret" column of the applicable target information.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

P3AM-3402-14ENZ0