Fujitsu ETERNUS HX Series 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Fujitsu ETERNUS HX Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS HX Series 8 페이지. Installing a cisco nexus 9336c-fx2 switch and pass-through panel in a cabinet, for cisco nexus 9336c-fx2 switches
Fujitsu ETERNUS HX Series에 대해서도 마찬가지입니다: 설치 (9 페이지)

페이지 인쇄

ALUA handles this automatically. If ALUA is not supported and you are using an MPIO environment, you

can use the dotpaths utility that comes with the Host Utilities to set the path priorities. If you enter

dotpaths without any options, it sets the priority for all Data ONTAP LUNs.

8. (PowerVM vSCSI environments) If you have LUNs presented to a VIO server from multiple third-party

storage vendors, make sure that all the LUNs use the same maximum transfer size.

Enter the following command: lsattr -El hdisk_name -a max_transfer

9. Display information about the LUNs and the HBAs by using the command sanlun. For example, to verify

that the host has discovered the LUNs, enter the command:sanlun lun show

If you are using multipathing, you can display information about the primary and secondary paths

available to the LUNs by entering the following command: sanlun lun show -p

Note: The sanlun command displays path information for each LUN; however, it only displays the

native multipathing policy. To see the multipathing policy for other vendors, you must use vendor-specific

commands.

| AIX Host Utilities 6.0 Quick Start Guide |