Fujitsu ETERNUS HX Series 설치 - 페이지 5

{카테고리_이름} Fujitsu ETERNUS HX Series에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS HX Series 9 페이지. Installing a cisco nexus 9336c-fx2 switch and pass-through panel in a cabinet, for cisco nexus 9336c-fx2 switches
Fujitsu ETERNUS HX Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

1. As you gently slide the slider rail, align it to the screw holes in the rack.

2. Tighten the screws of the slider rails to the cabinet posts.

b) Repeat step

for the right side rear post.

c) Repeat steps

and

5. Install the switch in the cabinet.

Attention: This step requires two people: one person to support the switch from the front and

another to guide the switch into the rear slider rails.

a) Position the back of the switch at RU41.

1. As the chassis is pushed toward the rear posts, align the two rear rack-mount guides with the slider

rails.

2. Gently slide the switch until the front rack-mount brackets are flush with the front posts.

b) Attach the switch to the cabinet.

| Installing a Cisco Nexus 9336C-FX2 switch and pass-through panel in a Fujitsu cabinet |

at the RU41 locations on the cabinet.