Fujitsu ETERNUS LT140 사용자 설명서 - 페이지 15
{카테고리_이름} Fujitsu ETERNUS LT140에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS LT140 47 페이지. Tape library
Fujitsu ETERNUS LT140에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)
페이지 인쇄
Chapter 1 Hardware Configuration
1.3 Library Controller
1.3
Library Controller
The library controller is located at the rear right of each module.
The library controller of the Base Module controls the system as the main controller.
The library controller of the Expansion Modules will not provide LAN ports and USB ports.
Figure 1.5 Library controller (Base Module/Expansion Module)
8
7
6
Base Module
1
Module Interconnect (to top)
2
USB Port (service) (not used) (*1)
3
LAN Port (DIAG) (service) (not used) (*1)
4
LAN Port (MGMT) (remote panel) (*1)
5
Module Interconnect (to bottom)
Unit Identifier LED (blue)
6
Controller Error LED (yellow)
7
Controller Health Status LED (green)
8
*1:
Only installed for Base Modules.
Table 1.3
LED Meanings (library controller)
No.
6
Unit Identifier
7
Controller Error
8
Controller Health Status
FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Site Planning-
1
2
3
4
5
LED state
Blue
The LED of the Unit ID (UID) is controlled by the user with the [Mainte-
nance > UID LED Control] screen of the operator panel or remote
panel.
The UID can be used for identifying the location of the data center
library.
Yellow
When lit, the controller is not functioning.
Green
When the state of the library controller is normal, the LED flashes
green.
15
Copyright 2018 FUJITSU LIMITED
1
8
7
6
5
Meaning
P3AG-3712-01ENZ0