Fujitsu ETERNUS2000 200 매뉴얼 - 페이지 8

{카테고리_이름} Fujitsu ETERNUS2000 200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS2000 200 21 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS2000 200에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지), 설정 매뉴얼 (4 페이지), 연결 매뉴얼 (19 페이지), 옵션 제품 사용 (2 페이지)

페이지 인쇄

Chapter 3

The MPxIO set up procedure is common to all ETERNUS2000, ETERNUS4000, and

ETERNUS8000 Disk storage systems, but some settings vary depending on the Solaris OS ver-

sion.

Set up MPxIO according to the Solaris OS version being used.

3.1

Solaris 10 OS

3.1.1

Disabling MPxIO on Some Paths

When multipathing is not required for the specific LUN, use the following procedure to add phys-

ical paths for the relevant device to the "/kernel/drv/fp.conf" file in order to disable the multipath

function for the device.

Disabling the multipath function is not necessary when multipathing is to be set up for all the

LUNs that are recognized by the OS. In these cases, proceed to

9).

P3AM-2722-04ENZ0

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris

Setting Up MPxIO

If this setting is omitted, multipathing is set up for all LUNs recognized by

the OS.

MPxIO must be disabled for the paths of connected devices that MPxIO

does not support (such as a tape device).

Procedure

Use the "cat" command (etc.) to check the "/etc/path_to_inst" file and identify the

physical pathname of the device for which multipathing is not required.

In this example, the physical path is "/pci@8,600000/SUNW,qlc@2"

# cat /etc/path_to_inst

"/pci@8,600000/SUNW,qlc@2" 0 "qlc"

"/pci@8,600000/SUNW,qlc@2/fp@0,0" 5 "fp"

"/pci@8,600000/SUNW,qlc@2/fp@0,0/ssd@w500000e0113ce2e1,0" 5 "ssd"

Physical path

Add the following line to the "/kernel/drv/fp.conf" file using the "vi" command.

name="fp" parent="Physical path" port=0 mpxio-disable="yes";

"3.1.2 Enabling MPxIO" (page