Fujitsu ETERNUS4000 400 매뉴얼 - 페이지 12

{카테고리_이름} Fujitsu ETERNUS4000 400에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS4000 400 28 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS4000 400에 대해서도 마찬가지입니다: 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

Chapter 4

The server information registered in the ETERNUS Disk storage system should be checked.

A variety of commands are used to check the following server information.

•

iSCSI Software Initiator

Since iSCSI Software Initiator is provided with the OS, installation is not required.

Check the SUNWiscsiu and SUNWiscsir packages using the "pkginfo" command.

•

iSCSI Initiator name

Execute the following command:

The iSCSI Initiator name is displayed in the "Initiator node name" column.

•

Server-side LAN card IP address for connecting to the ETERNUS Disk storage system

Execute the following command:

Set this IP address if it is not already set.

•

Initiator CHAP Name

The Initiator CHAP Name is the user name for unidirectional CHAP authentication, and is not

required if CHAP authentication is not used.

Execute the following command:

The Initiator CHAP Name is displayed in the "CHAP Name" column of the applicable target

information.

P3AM-4182-03ENZ0

Server Connection Guide (iSCSI) for Oracle Solaris

Checking the Server Information

# iscsiadm list initiator-node

# ifconfig -a

# iscsiadm list initiator-node