Fujitsu ETERNUS4000 400 연결 매뉴얼 - 페이지 13

{카테고리_이름} Fujitsu ETERNUS4000 400에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS4000 400 19 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS4000 400에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지)

페이지 인쇄

Chapter 3 Setting Up the Server

3.2 Setting Up Brocade Fibre Channel Cards

The following procedure shows an example for setting the port speed, topology, and frame data

size.

Procedure

P3AM-4562-01ENZ0

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris

Check the "port_id" of the target port.

# bcu port --list

Port#

Type

PWWN/MAC

1/0

10:00:00:05:1e:e7:45:7b

1/1

10:00:00:05:1e:e7:45:7c

Check the port ID

The port ID checked here is used to set the port speed, topology, and frame data size.

Set the port speed to "8G".

# bcu port --speed 1/0 8

Setting will be enforced after port --disable and -enable

Set the topology to "p2p".

# bcu port --topology 1/0 p2p

Setting will be enforced after port --disable and --enable

Set the frame data size to "2048".

# bcu port --dfsize 1/0 2048

Setting will be enforced after port --disable and -enable

Execute the "port disable|enable" command to apply the port speed, topology,

and frame data size settings.

# bcu port --disable 1/0

port disabled

# bcu port --enable 1/0

port enabled

Check the port speed, topology, and frame data size that have been set.

•

Port speed confirmation

# bcu port --speed 1/0

Current port speed is:

Configured port speed is:

•

Topology confirmation

# bcu port --topology 1/0

Current topology is:

Configured topology is:

FC Addr/ Media

Eth dev

010400

010500

P2P

State

Spd

Linkup