Fujitsu ETERNUS4000 600 서버 연결 매뉴얼 - 페이지 28

{카테고리_이름} Fujitsu ETERNUS4000 600에 대한 서버 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS4000 600 32 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS4000 600에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (25 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

1. Chapter 4 Installing and Setting up Eternusmgr

Chapter 10 Checking the Connected Devices

10.3 Checking the ETERNUS Disk Storage Systems' Connection Status

10.3

Checking the ETERNUS Disk Storage Systems'

Connection Status

The following items can be set and displayed in the "GR Multipath Manager" main window when

"GR Multipath Driver" or "ETERNUS Multipath Driver" is used.

•

ETERNUS Disk storage systems' connection status

•

Connected LUNs

•

Path status

•

Path restoration or release

The following are example uses of "ETERNUS Multipath Driver".

These describe ETERNUS Disk storage systems' connection status and the checking of paths.

Procedure

For details on "Multipath Manager" operations, refer to the manual provided with the "GR

Multipath Driver" or "ETERNUS Multipath Driver".

P3AM-2922-05ENZ0

ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for Windows®

For multipath configuration with Windows Server® 2008 R2 or

Windows Server® 2008, each ETERNUS Disk storage system LUN

shows as a single "Multi-Path Disk Device".

For multipath configuration with Windows Server® 2003 or

Windows® 2000 Server, the number of LUNs shown will be the same

as the number of paths which connect to each ETERNUS Disk

storage system LUN. For example, if two paths (Main Path and 2nd

Path) are connected to a LUN, then two LUNs are displayed under

[Disk drives], even though there is only one actual LUN.

Start up ETERNUS Disk storage systems (assuming that LUNs are already set

up), and check that it is "Ready" before starting up the server.

When the server is Ready, start up Multipath Manager.

The main window will appear. The status of the ETERNUS Disk storage systems

connected to the server (connection status, path status) can be checked.

End of procedure