Fujitsu ETERNUS4000 600 연결 매뉴얼 - 페이지 13

{카테고리_이름} Fujitsu ETERNUS4000 600에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS4000 600 19 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS4000 600에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지)

Fujitsu ETERNUS4000 600 연결 매뉴얼
Chapter 3 Setting Up the Server
>
3.2 Setting Up Brocade Fibre Channel Cards
The following procedure shows an example for setting the port speed, topology, and frame data
size.
Procedure
1
2
3
4
5
6
P3AM-4562-01ENZ0
ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris
Check the "port_id" of the target port.
# bcu port --list
Port#
Type
PWWN/MAC
1/0
fc
10:00:00:05:1e:e7:45:7b
1/1
fc
10:00:00:05:1e:e7:45:7c
Check the port ID
The port ID checked here is used to set the port speed, topology, and frame data size.
Set the port speed to "8G".
# bcu port --speed 1/0 8
Setting will be enforced after port --disable and -enable
Set the topology to "p2p".
# bcu port --topology 1/0 p2p
Setting will be enforced after port --disable and --enable
Set the frame data size to "2048".
# bcu port --dfsize 1/0 2048
Setting will be enforced after port --disable and -enable
Execute the "port disable|enable" command to apply the port speed, topology,
and frame data size settings.
# bcu port --disable 1/0
port disabled
# bcu port --enable 1/0
port enabled
Check the port speed, topology, and frame data size that have been set.
Port speed confirmation
# bcu port --speed 1/0
Current port speed is:
Configured port speed is:
Topology confirmation
# bcu port --topology 1/0
Current topology is:
Configured topology is:
FC Addr/ Media
Eth dev
010400
sw
010500
sw
8G
8G
P2P
P2P
13
State
Spd
Linkup
8G
Linkup
8G
Copyright 2010 FUJITSU LIMITED