Fujitsu ETERNUS4000 model 300 연결 매뉴얼 - 페이지 9
{카테고리_이름} Fujitsu ETERNUS4000 model 300에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS4000 model 300 19 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS4000 model 300에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지)
페이지 인쇄
Chapter 3
The server setup will vary according to how the ETERNUS Disk storage systems and server are
to be connected. Only Fabric connections are supported.
The Fibre Channel card Instance name, target WWN, and target ID information are necessary.
Check each item and enter them in the list. Edit the configuration file according to those informa-
tion and make settings.
Refer to the following to set.
• "3.1 Creating a WWN Instance Management Table for the Server" (page 9)
• "3.2 Setting Up Brocade Fibre Channel Cards" (page 12)
• "3.3 Setting the Configuration File (/etc/system)" (page 14)
3.1
Creating a WWN Instance Management Table for the
Server
Determine the following information for each Fibre Channel card installed in the server and enter
it into a copy of the "WWN instance management table for the server" (provided in
Management Table Template" (page
•
Physical slot name
•
WWN
•
Number of the target controller connected to the Fibre Channel card
•
Instance name
•
Physical path name
WWN Instance Management Table for the Server
Physical slot name
1
P3AM-4562-01ENZ0
ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris
Setting Up the Server
WWN
Procedure
Check the instance names.
"bfa + instance number" is the format used to represent Fibre Channel card instance
names.
17)).
Controller
Instance
Physical path name
name
name
9
"Appendix A
Copyright 2010 FUJITSU LIMITED