Fujitsu ETERNUS8000 1100 서버 연결 매뉴얼 - 페이지 15

{카테고리_이름} Fujitsu ETERNUS8000 1100에 대한 서버 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS8000 1100 32 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS8000 1100에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (25 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

1. Chapter 4 Installing and Setting up Eternusmgr

Chapter 3 Notes

3.5 MSCS and WSFC Notes

3.5

MSCS and WSFC Notes

•

To use MSCS or WSFC configuration, install the driver for ETERNUS Disk storage systems or

either the Windows Server® 2008 R2 or the Windows Server® 2008 standard multipath driver

(msdsm) on each node (server), and then check the connections before MSCS or WSFC

installation.

•

Check the registry values by following the instructions in

Information" (page

•

When setting up the MSCS, a reset group must be set for the ETERNUS Disk storage

system. A reset group does not need to be set for WSFC.

3.6

VERITAS Storage Foundation for Windows (SFW)

Notes

•

Installing VERITAS Storage Foundation for Windows

VERITAS Storage Foundation for Windows should be installed as specified in its accompany-

ing documentation.

•

VERITAS Device Driver Installation (DDI)

If the ETERNUS Disk storage systems are connected to a configuration that uses the VERI-

TAS Storage Foundation for Windows, the VERITAS DDI will also need to be installed.

Note that the VERITAS DDI must be installed after the VERITAS Storage Foundation for Win-

dows installation.

Refer to the Symantec web-site for VERITAS DDI installation details.

SFW 5.0 or later

SFW 5.1

SFW 5.1 SP1 or later

•

Checking the Load Balance Policy setting

For multipath configurations, make sure that "Round Robin(Active/Active)" is set for the Load

Balance Policy setting.

P3AM-2922-05ENZ0

ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for Windows®

26), after installing MSCS or WSFC.

SFW version

http://support.veritas.com/docs/326335

http://support.veritas.com/docs/326334

VERITAS DDI installation is not required.

•

In the "DSM Selection" window that appears during the VERITAS

DDI installation, select "FUJITSU ETERNUS 2000 Array" regardless

of the ETERNUS Disk storage system to be connected.

Only "FUJITSU ETERNUS 2000 Array" is displayed on the "DSM

Selection" window. Other ETERNUS Disk storage systems are not

displayed.

•

When VERITAS Storage Foundation for Windows 5.1 SP1 is newly

installed, VERITAS DDI installation is not required.

"Chapter 9 Checking the Registry

VERITAS DDI download URL