Fujitsu ETERNUS8000 2100 매뉴얼 - 페이지 6

{카테고리_이름} Fujitsu ETERNUS8000 2100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS8000 2100 21 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS8000 2100에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

Chapter 1

This chapter describes how to set up a multipath connection using MPxIO.

Refer to

When the CPU that is installed in the server is x64, the default setting values for MPxIO are

enabled.

Confirm that the default value for MPxIO is enabled in Step 2 of the following workflow.

Workflow

P3AM-2722-04ENZ0

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris

Workflow

"Chapter 3 Setting Up MPxIO" (page 8)

Disable MPxIO on paths not requiring it (/kernel/drv/fp.conf)

Specify any devices that will not form part of the multipath connection.

Solaris 10 OS

"3.1 Solaris 10 OS" (page 8)

Change Settings

(/kernel/drv/fp.conf,

/kernel/drv/scsi_vhci.conf)

1. Enable multipathing.

2. Enable the auto-failback

function.

Effect the Changed Settings

Reconfigure the server and restart it.

Multipath Status Check

Check the status of the multipath connection after the MPIO settings are complete.

for more details.

Solaris 9 OS

"3.2 Solaris 9 OS" (page 12)

Change Settings

(/kernel/drv/scsi_vhci.conf)

1. Enable multipathing.

2. Enable the auto-failback

function.

Solaris 8 OS

"3.3 Solaris 8 OS" (page 16)

Change Settings

(/kernel/drv/scsi_vhci.conf)

1. Enable multipathing.

2. Enable the auto-failback

function.

3. Enable the Symmetric

option.