Fujitsu ETERNUS8000 2100 서버 연결 매뉴얼 - 페이지 14

{카테고리_이름} Fujitsu ETERNUS8000 2100에 대한 서버 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS8000 2100 25 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS8000 2100에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (32 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

Chapter 5 Setting Up the Linux Server

5.2 Setting Up Automatic iSCSI Service

5.2

Setting Up Automatic iSCSI Service

YaST is used to set up the iSCSI service. Refer to the Novell web-site for details of the setup pro-

cedure.

Procedure

5.3

Setting Up the Network Environment

Set the IP information (IP address and subnet mask) of the LAN card.

5.4

Checking the iSCSI Initiator Name

Check which iSCSI initiator name is described as the default in the "/etc/iscsi/initiatorname.iscsi"

file.

This iSCSI initiator name should be used for the ETERNUS Disk storage system settings.

P3AM-4152-02ENZ0

ETERNUS Disk storage systems Server Connection Guide (iSCSI) for Linux

(SUSE Linux Enterprise Server)

Start YaST and then run the iSCSI Initiator in Miscellaneous.

The iSCSI Initiator Overview window appears.

In the iSCSI Initiator Overview window, open the Service tab and select "When

Booting".

Set the same subnet as that set for the ETERNUS Disk storage system

LAN card.

For details of the ETERNUS Disk storage system settings, refer to

7 Setting Up the ETERNUS Disk Storage Systems" (page

End of procedure

"Chapter

16).