Fujitsu ETERNUS8000 2100 서버 연결 매뉴얼 - 페이지 19

{카테고리_이름} Fujitsu ETERNUS8000 2100에 대한 서버 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS8000 2100 25 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS8000 2100에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 매뉴얼 (21 페이지), 서버 연결 매뉴얼 (32 페이지), 연결 매뉴얼 (19 페이지)

페이지 인쇄

Chapter 8 ETERNUS Disk Storage System Logical Unit Recognition

8.3 When Bidirectional CHAP Authentication is Used

8.3

When Bidirectional CHAP Authentication is Used

Procedure

4-1

4-2

4-3

4-4

4-5

4-6

4-7

6-1

6-2

6-3

6-4

6-5

P3AM-4152-02ENZ0

ETERNUS Disk storage systems Server Connection Guide (iSCSI) for Linux

(SUSE Linux Enterprise Server)

Start YaST and then run the iSCSI Initiator in Miscellaneous.

Select the "Discovered Targets" tab and click the [Discovery] button to open the

iSCSI Initiator Discovery dialog.

Set the IP address for the ETERNUS Disk storage system iSCSI port in "IP

Address".

Keep the default port number value (3260).

Perform the following procedure when bidirectional CHAP is used.

Select "Incoming Authentication".

Enter the UserName that is set in iSCSI Host of the ETERNUS Disk storage system in

"UserName".

Enter the Password that is set in iSCSI Host of the ETERNUS Disk storage system in

"Password".

Select "Outgoing Authentication".

Enter the UserName that is set in "Set iSCSI Port Parameters" of the ETERNUS Disk

storage system in "UserName".

Enter the Password that is set in "Set iSCSI Port Parameters" of the ETERNUS Disk

storage system in "Password".

Click the [Next] button.

Check that the desired Target is visible in the "Discovered Targets" tab.

The "Connected" state of the Target should be "False" at this time.

Select the desired Target in the "Discovered Targets" tab, and click the [Log In]

button to re-open the CHAP selection dialog.

Perform the following procedure for unidirectional CHAP authentication.