Fujitsu ETERNUS8000 model 700 연결 매뉴얼 - 페이지 13

{카테고리_이름} Fujitsu ETERNUS8000 model 700에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS8000 model 700 19 페이지. Disk storage systems (fibre channel) for oracle solaris
Fujitsu ETERNUS8000 model 700에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 서버 연결 매뉴얼 (25 페이지), 서버 연결 매뉴얼 (32 페이지)

페이지 인쇄

Chapter 3 Setting Up the Server

3.2 Setting Up Brocade Fibre Channel Cards

The following procedure shows an example for setting the port speed, topology, and frame data

size.

Procedure

P3AM-4562-01ENZ0

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris

Check the "port_id" of the target port.

# bcu port --list

Port#

Type

PWWN/MAC

1/0

10:00:00:05:1e:e7:45:7b

1/1

10:00:00:05:1e:e7:45:7c

Check the port ID

The port ID checked here is used to set the port speed, topology, and frame data size.

Set the port speed to "8G".

# bcu port --speed 1/0 8

Setting will be enforced after port --disable and -enable

Set the topology to "p2p".

# bcu port --topology 1/0 p2p

Setting will be enforced after port --disable and --enable

Set the frame data size to "2048".

# bcu port --dfsize 1/0 2048

Setting will be enforced after port --disable and -enable

Execute the "port disable|enable" command to apply the port speed, topology,

and frame data size settings.

# bcu port --disable 1/0

port disabled

# bcu port --enable 1/0

port enabled

Check the port speed, topology, and frame data size that have been set.

•

Port speed confirmation

# bcu port --speed 1/0

Current port speed is:

Configured port speed is:

•

Topology confirmation

# bcu port --topology 1/0

Current topology is:

Configured topology is:

FC Addr/ Media

Eth dev

010400

010500

P2P

State

Spd

Linkup