AEG PNC914550488 사용자 설명서 - 페이지 26
{카테고리_이름} AEG PNC914550488에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG PNC914550488 44 페이지.
페이지 인쇄
26
www.aeg.com
1. Touch the Início/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Início Diferido button
repeatedly until the display shows
the desired delay time.
3. Touch the Início/Pausa button again
to start the new countdown.
11.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Início/Pausa button,
the maximum declared load indicator
goes off, the indicator
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum
rotates shortly.
2. At the end of the load detection, the
indicator
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Início/Pausa button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
flashes, the
goes off and the time
About 20 minutes after the
programme start, the
programme duration could
be adjusted again
depending on the capacity
of water absorption of the
fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
11.9 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
and
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the Vapor Plus the steam
phase indicators come on.
The steam phase is running:
is
The anti-crease phase is running:
.
11.10 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the Início/Pausa button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Início/Pausa button again.
The washing programme continues.
.
.
.