Fujitsu M2488 사용 설명서 - 페이지 3

{카테고리_이름} Fujitsu M2488에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu M2488 4 페이지.

STEP

ACTION

10 (con't)

BLOCK size (0=variable length)

Use DEVICE BUFFERS during writes

Use EXTENDED ﬁlemarks

BLOCKSIZE for variable length support

DENSITY setting #1

DENSITY setting #2

Set delay after a FAILED command

Set maximum delay for the READ/WRITE command

Select DO.

To leave smit, select Done, Cancel, Cancel, and Cancel. The smit window will close.

To test the M2488 save the "passwd" ﬁle to tape using the tar command:

tar -cvf /dev/rmt0 /etc/passwd

The system responds with: a /etc/passwd 1 blocks

Note: depending on the size of the ﬁle, a different number of blocks may be reported.

Verify that the "passwd" ﬁle was saved to tape by executing the following command:

tar tf /dev/rmt0

The system responds with: /etc/passwd

Installation and veriﬁcation of the system is now complete.

NOTES

It is assumed that the user has a standard M2488 and is familiar with the SCSI-2 standard and host operating system

conventions.

The user assumes all responsibility for understanding the interrelationships of this information with other affected

software or system products. Fujitsu Computer Products of America (FCPA) provides this information as a service

only, and assumes no responsibility for any damages which could result from the use of this information.

The information in this application note is subject to change without notice and is not to be construed as a commit-

ment by FCPA.

May 1996

YES

Do not set to NO

120

CG00000-016401

3 of 4