AEG ProSteam LR73CW86 사용자 설명서 - 페이지 26
{카테고리_이름} AEG ProSteam LR73CW86에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ProSteam LR73CW86 44 페이지.
페이지 인쇄
26
www.aeg.com
12.8 The ProSense
Technology load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze - Départ/
Pause button, the maximum declared
load indicator goes off, the indicator
flashes, the ProSense Technology starts
the laundry load detection:
1. The appliance detects the load in the
first 30 seconds, the indicator
flashes, the drum rotates shortly.
2. At the end of the load detection, the
indicator
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ/Pause
button to start the programme again. The
ProSense Technology phase can be
repeated up to three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense Technology
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
stop flashing. The
The ProSense Technology is
not available with some
programmes, such as Wol -
Laine, programmes with
short cycles and without
washing phase.
12.9 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the Plus Steam the steam
is
phase indicators come on.
The steam phase is running:
The anti-crease phase is running:
.
12.10 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the button Start/Pauze -
Départ/Pause.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pauze -
Départ/Pause again.
The washing programme continues.
12.11 Cancelling a running
programme
1. Press the button Aan/Uit - Marche/
Arrêt to cancel the programme and to
deactivate the appliance.
.
.
.