AEG REGINA 1580 사용자 정보 - 페이지 18

{카테고리_이름} AEG REGINA 1580에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG REGINA 1580 44 페이지. Environmentally friendly washing machine

User information

Adding washing

1. Press the START/PAUSE key (DEPART/PAUSE).

• If "Door locked" and "Pause" are alternately shown in the display, it

is no longer possible to add washing, e. g. when the water level is

too high.

• If "Door unlocked" and "Pause" are alternately shown in the

display, it is still possible to add washing :

2. Open the door.

3. Add washing and close the door again.

4. Press the START/PAUSE key (DEPART/PAUSE) again. The programme

continues.

Washing cycle complete / Removing the washing

At the end of the cycle a long acoustic signal sounds 3 times (when the

SOUND VOLUME setting is NORMAL or LOW) and the messages "Cycle

ended" and "Door openable" appear alternately in the display.

1. Open the door and remove the washing.

2. Turn the programme knob to OFF.

3. After the wash, pull out the detergent dispenser drawer slightly to

allow it to dry. Leave the door slightly open to air the inside of the

washing machine.

If RINSE HOLD

After a Rinse Hold or when a programme with NIGHT CYCLE has ended,

the START/PAUSE indicator flashes. "Cycle ended" and "Door locked"

appear alternately in the display.

The water must first be drained :

• Turn the programme knob to OFF, then to DRAIN (VIDANGE) and

press the START/PAUSE key (DEPART/PAUSE) (the water is drained

without spinning), or

• Turn the programme knob to OFF and then to SPIN (ESSORAGE).

Change the spin speed if necessary and press the START/PAUSE key

(DEPART/PAUSE) (the water is drained and the washing spun).

or NIGHT CYCLE

was selected :