AEG 6000 Series 사용자 설명서 - 페이지 4
{카테고리_이름} AEG 6000 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 6000 Series 24 페이지.
AEG 6000 Series에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (24 페이지), 사용자 설명서 (24 페이지)
페이지 인쇄
4
www.aeg.com
store raw meat and fish in suitable containers in the
–
refrigerator, so that it is not in contact with or drip
onto other food.
WARNING: Keep ventilation openings, in the
•
appliance enclosure or in the built-in structure, clear of
obstruction.
WARNING: Do not use mechanical devices or other
•
means to accelerate the defrosting process, other than
those recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.
•
WARNING: Do not use electrical appliances inside the
•
food storage compartments of the appliance, unless
they are of the type recommended by the
manufacturer.
Do not use water spray and steam to clean the
•
appliance.
Clean the appliance with a moist soft cloth. Only use
•
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
When the appliance is empty for long period, switch it
•
off, defrost, clean, dry and leave the door open to
prevent mould from developing within the appliance.
Do not store explosive substances such as aerosol
•
cans with a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by
•
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
2. SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not use the appliance before
installing it in the built-in structure due
to safety manner.
• Follow the installation instructions
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Make sure the air can circulate
around the appliance.
• At first installation or after reversing
the door wait at least 4 hours before
connecting the appliance to the power
supply. This is to allow the oil to flow
back in the compressor.