Brother MFC-J4610DW 여기에서 시작하기 매뉴얼 - 페이지 36

{카테고리_이름} Brother MFC-J4610DW에 대한 여기에서 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J4610DW 47 페이지. Quick setup guide - spanish
Brother MFC-J4610DW에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (47 페이지), 매뉴얼 (36 페이지), 매뉴얼 (22 페이지), 제품 안전 매뉴얼 (17 페이지), 매뉴얼 (13 페이지), 매뉴얼 (13 페이지), 빠른 설정 매뉴얼 (45 페이지), 제품 안전 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (29 페이지), 제품 안전 매뉴얼 (25 페이지), (스페인어) 웹 연결 매뉴얼 가이드 (38 페이지), (스페인어) 매뉴얼 (24 페이지), (영어) 제품 안전 가이드 매뉴얼 (16 페이지), (스페인어) 매뉴얼 (12 페이지), (스페인어) 매뉴얼 (11 페이지), (영어) 빠른 구성 가이드 (47 페이지)

For Wireless Network Users

Troubleshooting

Please do not contact Brother Customer Service for assistance without the wireless security

information. We cannot assist you in locating your network security settings.

How can I find the wireless security information (SSID and Network Key)

1) You should see the documentation provided with your wireless access point/router.

2) The initial SSID could be the manufacturer's name or the model name.

3) If you do not know the security information, please consult the router manufacturer, your system

administrator or internet provider.

* The Network Key may also be described as the Password, Security Key or Encryption Key.

If the wireless LAN report that printed shows that the connection failed, check the error code on the printed report

and refer to the following instructions.

Error code

TS-01

TS-02

The wireless setting is not activated, turn the wireless setting to ON.

- If a network cable is connected to your machine, disconnect it and turn the wireless setting

of your machine to ON.

On your machine, press Settings.

Press s or t to display Network, and then press Network.

Press s or t to display Network I/F.

Press Network I/F.

Press WLAN.

Press

The wireless access point/router cannot be detected.

1. Check the following 4 points.

- Make sure that the wireless access point/router is powered on.

- Move your machine to an obstruction-free area, or closer to the wireless access

point/router.

- Temporarily place your machine within about one metre from the wireless access point

when you are configuring the wireless settings.

- If your wireless access point/router is using MAC address filtering, confirm the MAC

address of the Brother machine is allowed in the filter.

2. If you manually entered the SSID and security information (SSID/authentication

method/encryption method/Network Key), the information may be incorrect.

Reconfirm the SSID and security information and re-enter the correct information as

necessary.

See How can I find the wireless security information (SSID and Network Key) on page 36 to

confirm.