Brother 2 매뉴얼 - 페이지 13

{카테고리_이름} Brother 2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 2 39 페이지. Hewlett-packard laser printer user guide
Brother 2에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)

Brother 2 매뉴얼
a
Pull the end of the material until it reaches the guide
channel.
• Check that the side to be cut faces up.
1
a Guide channel
b Material
b
Make sure the left edge of the material is aligned with the
rolled material guide and the end of the material is
perfectly aligned with the guide channel.
When aligned
The end of the material is perfectly aligned. There is
no need to evenly trim the end of the material.
Proceed to the "Attaching the Leader Sheet to
the Material" procedure on page 14, attach the
leader sheet to the material, and place it on the
cutting machine.
1
a Rolled material guide
b Guide channel
c Material
When not aligned
The end of the material is not perfectly aligned. The
end of the material must be evenly trimmed.
For details, see "Evenly Trimming the End of the
Material" on page 12.
1
a Rolled material guide
b Guide channel
c Material
12
1
2
2
3
2
3

Evenly Trimming the End of the Material

a
Pull the end of the material until it extends past the guide
channel.
a Guide channel
b
Remove the trimmer from the roll holder.
a Trimmer
c
Install the trimmer over the material.
Align the holes in the trimmer with the pins in the base attachment
as shown below.
1
2
a Hole in trimmer
b Pin on base attachment
d
Align the left edge of the material with the rolled material
guide.
1
a Rolled material guide
1
1
1
2