AEG AIK2683L 사용자 설명서 - 페이지 12

{카테고리_이름} AEG AIK2683L에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AIK2683L 36 페이지.
AEG AIK2683L에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지)

페이지 인쇄

www.aeg.com

Problem

There is too much frost and

ice.

Water flows on the rear

plate of the refrigerator.

Water flows inside the refrig-

erator.

Water flows on the floor.

The temperature in the ap-

pliance is too low/too high.

Possible cause

The door is not closed cor-

rectly.

The door is not closed cor-

rectly or the gasket is de-

formed/dirty.

The water drainage plug is

not correctly positioned.

Appliance is fully loaded

and it is set to the lowest

temperature

Temperature set in the ap-

pliance is too low and the

ambient temperature is

too high.

Temperature is set incor-

rectly.

During the automatic de-

frosting process, frost

melts on the rear plate.

Food products prevent the

water to flow into the wa-

ter collector.

The water outlet is clog-

ged.

The melting water outlet is

not connected to the

evaporative tray above the

compressor.

The temperature regulator

is not set correctly.

The door is not closed cor-

rectly.

The food products' tem-

perature is too high.

Many food products are

stored at the same time.

The thickness of the frost is

greater than 4-5 mm.

Solution

Refer to "Closing the door".

Position the water drainage

plug in the correct way.

Set a higher temperature. Re-

fer to "Operation".

Set a higher temperature. Re-

fer to "Operation"

Refer to "Operation" .

This is correct.

Make sure that food products

do not touch the rear plate.

Clean the water outlet.

Attach the melting water out-

let to the evaporative tray.

Set a higher/lower tempera-

ture.

Refer to "Closing the door".

Let the food products temper-

ature decrease to room tem-

perature before storage.

Add less food products at the

same time.

Defrost the appliance.