AEG AIK2853R 사용자 설명서 - 페이지 17

{카테고리_이름} AEG AIK2853R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AIK2853R 44 페이지.
AEG AIK2853R에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지)

페이지 인쇄

Problem

Water flows on the rear plate

of the refrigerator.

There is too much con‐

densed water on the rear

wall of the refrigerator.

Water flows inside the refrig‐

erator.

Water flows on the floor.

Temperature cannot be set.

The temperature in the appli‐

ance is too low/too high.

Possible cause

The gasket is deformed or

dirty.

Food products are not wrap‐

ped properly.

Temperature is set incorrect‐

ly.

Appliance is fully loaded and

is set to the lowest tempera‐

ture.

Temperature set in the appli‐

ance is too low and the am‐

bient temperature is too

high.

During the automatic de‐

frosting process, frost melts

on the rear plate.

Door was opened too fre‐

quently.

Door was not closed com‐

pletely.

Stored food was not wrap‐

ped.

Food products prevent the

water from flowing into the

water collector.

The water outlet is clogged.

The melting water outlet is

not connected to the evapo‐

rative tray above the com‐

pressor.

The "Frostmatic function" is

switched on.

The temperature is not set

correctly.

ENGLISH

Solution

Refer to "Closing the door"

section.

Wrap the food products bet‐

ter.

Refer to "Control Panel"

chapter.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Set a higher temperature.

Refer to "Control Panel"

chapter.

This is correct.

Open the door only when

necessary.

Make sure the door is closed

completely.

Wrap food in suitable pack‐

aging before storing it in the

appliance.

Make sure that food prod‐

ucts do not touch the rear

plate.

Clean the water outlet.

Attach the melting water out‐

let to the evaporative tray.

Switch off "Frostmatic func‐

tion" manually, or wait until

the function deactivates au‐

tomatically to set the temper‐

ature. Refer to "Frostmatic

function" section.

Set a higher/lower tempera‐

ture.