AEG ARCTIS 사용 설명서 - 페이지 22

{카테고리_이름} AEG ARCTIS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ARCTIS 23 페이지. Built-in fridge-freezers
AEG ARCTIS에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지), 사용 설명서 (28 페이지), 사용 설명서 (40 페이지), 사용 설명서 (28 페이지), 작동 지침 (16 페이지), 사용 설명서 (36 페이지), 사용 설명서 (36 페이지), 사용 설명서 (26 페이지), 사용 설명서 및 설치 매뉴얼 (28 페이지), 사용 설명서 (36 페이지), 사용 설명서 (27 페이지), 사용 설명서 (34 페이지), 사용자 설명서 (24 페이지), 설치 지침 매뉴얼 (11 페이지), 사용 설명서 (29 페이지), 설치 지침 매뉴얼 (25 페이지), 설치 지침 매뉴얼 (24 페이지)

The refrigerant circuit has been checked for leaks.

This appliance is in accordance with the following EU guidelines:

– 73/23/EWG dated 19 February 1973 - low voltage guidelines.

– 89/336/EWG dated 3 May 1989

(including guideline change notice 92/31/EWG) - EMV guideline

– 94/2/EG dated 21.01.1994 - Directive on Energy Labelling

– 96/57 EG dated 3.9.1996 - Energy Efficiency Requirements of

Household Electric Refrigerators, Freezers and Combinations Thereof.

Technical terminology

• Refrigerant

Liquids that can be used to a generate a cooling effect are known as

refrigerants. They have a relatively low boiling-point, indeed so low,

that the warmth from the food stored in the fridge or freezer can

cause the refrigerant to boil and vaporise.

• Refrigerant Circuit

Closed circulation system that contains the refrigerant. The refriger-

ant circuit comprises primarily of an evaporator, a compressor, a con-

denser and pipe work.

• Evaporator

The refrigerant is evaporated in the evaporator. Similar to all other

liquids, refrigerant requires heat to evaporate. This heat is removed

from the interior of the appliance, as a result the interior is cooled.

The evaporator is therefore located inside the appliance or placed in

foam immediately behind the inner wall and thus not visible.

• Compressor

The compressor looks like a small drum. It is driven by a built-in

electric motor and is mounted on the base of the appliance at the

rear. The task of the compressor is to draw in vaporised refrigerant

from the evaporator, to compress it, and to pass it on to the con-

denser.

• Condenser

The condenser normally has the form of a grid. The refrigerant com-

pressed in the compressor is liquefied in the condenser. During this

process, heat is released to the surrounding air at the surface of the

condenser. The condenser is mounted on the base of the appliance.