AEG Automatic Refrigerator 사용 설명서 - 페이지 9

{카테고리_이름} AEG Automatic Refrigerator에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG Automatic Refrigerator 11 페이지. Aeg automatic washing machines
AEG Automatic Refrigerator에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지), 설치 및 연결 지침 (14 페이지)

페이지 인쇄

Adjusting the storage racks

If you want to adjust the distance between the stor-

age racks to accommodate taller containers, you

should pull the storage rack slightly forwards until it

can be swivelled upwards or downwards and re-

moved. To insert at another level, please proceed in

the reverse sequence.

Icemaking

Fill the ice-tray

full with cold water, place it in the

icemaking compartment, and allow it to freeze. The

ice-cubes can be easily loosened by twisting the

icetray or by holding it brieﬂy under running water.

Never loosen the frozen-on ice-tray with sharp or

pointed objects, since you may damage the refrig-

erating circuit.

Defrosting

Fig. 8

The appliance should be defrosted whenever a frost

layer of around 4 mm builds on the evaporator.

Before defrosting, empty the icemaking compart-

ment, ensuring that the thaw water collector is

below the evaporator.

The defrosting knob is located at the centre of the

regulator knob (Fig. 8, A). This is pressed in until it

engages. The setting of the temperature regulator

thereby remains unchanged. Do not forget to re-

move the thaw water and to dry the evaporator.

You can accelerate the defrosting process by plac-

ing a bowl of warm water inside the appliance and

keeping the door closed.

For safety reasons, no additional heat sources, such

as e. g. an electric heater or the like, should be used

during defrosting. When the frost layer has melted,

wipe the surfaces well dry. After the defrosting pro-

cess, the refrigerator switches on automatically.

Cleaning and care

Your refrigerator should be cleaned at regular inter-

vals. This is best done when it is empty or contains

little food.

During cleaning, your refrigerator should basically be

disconnected (unplugged) from the electricity supply.

Some organic solvents as well as essential oils (e. g.

juice from lemon and orange peel, butyric acid) at-

tack the plastic parts. Do not forget that, even in the

refrigerator, food stored too long may spoil. To pre-

vent any odours from forming, the contents should

therefore be checked from time to time (including

accessories) and thoroughly cleaned with lukewarm

water to which a mild detergent can be added. Fi-

nalIy, wash with clean water and wipe dry. After

cleaning, promptly restart your appliance.

When not in use

If your refrigerator is to remain unused for any length

of time, it must be disconnected (unplugged) from

the electricity supply. Remove all refrigerated and

deep-frozen packages as well as ice-trays, clean

the refrigerator compartment thoroughly, and leave

the door ajar to prevent any odours from forming.

Internal lighting

Light bulb data: 220 V, 12 W

E 14 socket (never use a bulb of more than 12 W).

Changing the light bulb:

Unplug or otherwise disconnect the appliance

from the mains supply (e. g. by removing the fuse).

Unscrew the light bulb from below and replace with

a new one.

Faults and servicing

To maintain the safety of your appliance, you should

only have repairs, especially on live parts, performed

by a trained electrician. In the event of a fault, please

contact your retailer or the service centre direct.

Before approaching the service centre, check

whether the plug socket is energized (connect light

bulb where necessary). Power supply faults can be

rectiﬁed by your electrician.

If your refrigerator has a fault, please notify the near-

est service centre promptly. To avoid unnecessary

journeys and costs, please quote

- the model designation,

- E-number and

- F-number of your refrigerator.

These data are indicated on the rating plate inside

your appliance on the LH side.

N. B.! Unjustiﬁed after-sales service calls must be

paid for even during the guarantee period.