Brother HL-760 Series 빠른 설정 매뉴얼 - 페이지 15

{카테고리_이름} Brother HL-760 Series에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-760 Series 17 페이지. Quick setup guide - english
Brother HL-760 Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (25 페이지), 서비스 매뉴얼 (44 페이지)

페이지 인쇄

English: HL-YL Quick Setup Guide, Body

Action 6-4: Prepare Macintosh for the Printer

You need to configure your computer for the printer by installing the printer driver and

TrueType-compatible fonts into the System Folder of your Macintosh computer, and select

your printer.

NOTE

You must have Macintosh System software version 6.0.7 or above to use this printer driver.

This printer driver only supports the 300 dpi mode when used with a Macintosh computer.

When setting up the printer to work with your Macintosh computer, you will need to use the

RS-422A serial interface. The serial interface board is an option. For information on options,

consult your dealer or refer to the User's Guide for this printer.

The supplied high density floppy disk contains the printer driver and TrueType-compatible

fonts necessary for this printer to work with Macintosh computers.

Be sure to follow the steps below to install the printer driver by using the installer software:

1. Start your Macintosh computer.

2. Insert the supplied disk for the Macintosh computer into the disk drive. If your computer

does not support high density 1.4 MB diskettes, please contact your dealer or Brother

Printer Support.

3. Double-click the disk icons to open your hard disk and the inserted disk.

4. Double-click the Installer icon.

5. The installer starts running. Follow the instructions on the computer screen.

NOTE

After you have installed the printer driver, you need to select your printer with the Chooser

(which is located under the Apple menu) on the Macintosh computer.