Fujitsu 9811 ATB 운영자 매뉴얼 - 페이지 19
{카테고리_이름} Fujitsu 9811 ATB에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu 9811 ATB 22 페이지. Printers
페이지 인쇄
Trouble Shooting
1. Reading the ERROR LOG from system memory.
1)
Push key "ON/OFF" to turn to mode "OFF LINE". LCD display shows "OFF LINE".
2)
Push key "TST" in order to show the memorized ERROR LOG.
Message will be displayed as
Time and Error Code are shown on LCD
Push key "ENT" to show details of the LOG.
Message will be displayed as
3)
Push key "+/-" to scroll the LCD display to show older ERROR LOG.
Push key "TST" to scroll backward to show younger ERROR LOG.
4)
When the scroll has reached the oldest error LOG, the following message is shown.
Repeating pushing the key "+/-" will return to the top.
5)
To finish the function: Push "ON/OFF" to finish the function and show "Ready to accept / ticket..."
on the LCD (return to ON LINE mode).
2.. Adjusting the system clock (to adjust it to local time).
F9811 Printer has an internal clock. Error codes are stored in memory time stamped.
1a)
Turn the power switch on.
BIOS will be started and several messages will appear on the display.
Please wait for the beep of buzzer.
1b)
Push the key "ON/OFF" on the keypad when you first hear the beep. Message will be displayed follows;
1c)
Push the key "3" after above message. (Just 3 not 1 and 2).
1d)
The LCD will display the clock and date to be adjusted as below.
1e)
Push numeric keys (0 - 9) in order to input each value of local time and date correctly.
1f)
Push the key "ENT", to register the local time. Message is displayed as follows;
1g)
When you push the key "1" , the message is displayed as follows.
1h)
Push the key "1" again. Printer is started automatically and returns to On-line mode.
3. Should an unexpected error occur,
2a)
Turn the power switch on.
BIOS will be started and several messages will be displayed on the LCD.
Please wait for the beep of buzzer.
2b)
Unexpectedly, the message is shown as same as (D06) on
2c)
If the system clock is incorrect, input correct values and set the system clock as described in 1E to 1H.
2d)
If the system clock is correct, register the system clock as above.
08/12/01 12:00
ERROR 0164
08/12/01 12:00
->PARITY ERR
----END OF LOG---
----TOP OF LOG---
1.Flash ROM inst
2.Boot from FDD
HH:MM mm/dd/yyyy
SELECT 128KB EMS
1=Yes 2=No
FDD INSTALLED:1
1=Yes 2=No
LCD.
18
Installing the Printer
->
(D01)
(D02)
(D03)
(D04)
all
(D05)
HH:
MM:
mm:
dd:
(D06)
yyyy
(D07)
(D08)
hour
minute
month
day
year