AEG OKO-SANTO 2972-6 i 작동 및 설치 지침 - 페이지 15

{카테고리_이름} AEG OKO-SANTO 2972-6 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-SANTO 2972-6 i 28 페이지. Integrating fridge freezer

페이지 인쇄

Symptom

The food is too warm.

Interior lighting does not

work.

Heavy build up of frost, pos-

sibly also on the door seal.

The compressor does not

start immediately after chan-

ging the temperature set-

ting.

Water on the floor or on sto-

rage shelves.

If, after carrying out the necessary checks there is still a fault with

your appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested

checks have been made as the engineer will make a charge if the

fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee

service calls.

Possible Cause

Temperature is not properly

adjusted.

Door was open for an exten-

ded period.

A large quantity of warm food

was placed in the appliance

within the last 24 hours.

The appliance is near a heat

source.

Light bulb is defective.

Door seal is not air tight

(possibly after reversing the

door).

This is normal, no error has

occurred.

Water drain hole is blocked.

Remedy

Please look in the "Initial

Start Up" section.

Open the door only as long

as necessary.

Turn the temperature control

knob to a colder setting.

Please look in the "Installa-

tion location" section.

Please look in the "Chan-

ging the Light Bulb" section.

Carefully warm the leaking

sections of the door seal

with a hair dryer (not hotter

than approx. 50 ¡C). At the

same time shape the war-

med door seal by hand until

it sits correctly.

The compressor starts after

a period of time.

See the "Cleaning and

Care" section.