AEG OKO-SANTO Series 사용 설명서 - 페이지 7

{카테고리_이름} AEG OKO-SANTO Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-SANTO Series 22 페이지. Automatic refrigerator
AEG OKO-SANTO Series에 대해서도 마찬가지입니다: 사용 설명서 (25 페이지)

페이지 인쇄

Remove transport safeguard

The appliance and the interior fittings are protected for transport.

Pull off the adhesive tape on the left and right side of the door.

You can remove any remnants of adhesive using white spirit.

Remove all adhesive tape and packing pieces from the interior of the

appliance.

Installation

Installation Location

The appliance should be set up in a well ventilated, dry room.

Energy use and efficient performance of the appliance is affected by

the ambient temperature. The appliance should therefore

– not be exposed to direct sunlight;

– not be installed next to radiators, cookers or other sources of heat;

– only be installed at a location whose ambient temperature corre

sponds to the climate classification, for which the appliance is desi-

gned.

The climate classification can be found on the serial plate, which is

located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for

each climate classification: each climate classification:

If installation next to a source of heat is unavoidable, the following

minimum clearances must be maintained at the sides of the appliance:

– for electric cookers 3 cm;

– for oil and coal fired ranges 30 cm.

If these clearances cannot be maintained a heat insulating pad is

required between the cooker and the refrigeration appliance.

If the refrigeration appliance is installed next to another refrigerator

or freezer a clearance of 5 cm at the sides is required, in order to pre-

vent the formation of condensation on the outside of the appliance.

Climate classification

for an ambient temperature of

+10 to +32 °C

+16 to +32 °C

+18 to +38 °C

+18 to +43 °C