AEG OKO-SANTO SUPER 2870-4 사용 설명서 - 페이지 16
{카테고리_이름} AEG OKO-SANTO SUPER 2870-4에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-SANTO SUPER 2870-4 32 페이지. Upright refrigerator
페이지 인쇄
0 Plug the mains plug into the mains socket.
0 Turn the temperature regulator to the desired setting with the aid of a
coin. The green mains power light illuminates. The compressor starts
and then runs automatically.
The following effects are of significance in respect of the interior tem-
perature:
– Ambient temperature;
– Quantity and temperature of the food stored;
– Frequency with which the door is opened and how long it is left open.
The following temperature settings can therefore only be considered as
recommendations that may well need to be adapted to suit your parti-
cular situation.
Recommended settings:
For normal use: position "1" to "2";
For lower temperatures: position "2" to "3".
Important!
High ambient temperatures (e.g. on hot summer days) and a cold set-
ting on the temperature regulator (position "3" to "4") can cause the
compressor to run continuously in order to maintain the low tempera-
ture.
The fridge will therefore not be able to defrost as automatic defrosting
of the fridge is only possible when the compressor is not running (see
"Defrosting" section). The result is the build up of a thick layer of frost
on the fridge rear wall.
If this happens, turn the temperature regulator back to a warmer set-
ting (position "2" to "3"). At this setting the compressor will be swit-
ched on and off as usual and automatic defrosting will restart.
Switching the Appliance Off
0 To switch off, turn the temperature regulator to position "0". The mains
power light goes out.
If the appliance is to be removed from service for a lengthy period:
0 Switch off the appliance. To do this turn the temperature regulator to
position "0". The mains power light goes out.
0 Unplug or switch off at the mains supply.
0 Clean thoroughly (see section: "Cleaning and Care").
0 Leave the door open to avoid the build up of odours.
818 14 28-00/7
17