AEG OKO_SANTO SUPER 사용 설명서 - 페이지 18

{카테고리_이름} AEG OKO_SANTO SUPER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO_SANTO SUPER 22 페이지. Automatic refrigerator
AEG OKO_SANTO SUPER에 대해서도 마찬가지입니다: 사용 설명서 (21 페이지), 사용 설명서 (32 페이지), 사용 설명서 (32 페이지)

페이지 인쇄

Malfunction

The food is too warm.

Interior lighting does not

work.

Heavy build up of frost,

possibly also on the door

seal.

Unusual noises.

The compressor does not

start immediately after

changing the temperature

setting.

Water on the floor or on

storage shelves.

Possible Cause

Temperature is not properly

adjusted.

Door was open for an

extended period.

A large quantity of warm

food was placed in the

appliance within the last

24 hours.

The appliance is near a

heat source.

Light bulb is defective.

Door seal is not air tight

(possibly after changing

over the hinges).

Appliance is not level.

The appliance is touching

the wall or other objects.

A component, e.g. a pipe,

on the rear of the applian-

ce is touching another part

of the appliance or the

wall.

This is normal, no error has

occurred.

Water drain hole is

blocked.

Remedy

Please look in the "Initial

Start Up" section.

Open the door only as long

as necessary.

Turn the temperature regu-

lator to a colder setting

temporarily.

Please look in the

"Installation location"sec-

tion.

Please look in the

"Changing the Light Bulb".

Carefully warm the leaking

sections of the door seal

with a hair dryer (not hot-

ter than approx. 50 °C).

At the same time shape the

warmed door seal by hand

such that it sits correctly.

Readjust the feet.

Move the appliance slight-

ly.

If necessary, carefully bend

the component out of the

way.

The compressor starts after

a period of time.

See the "Cleaning and

Care" section.