Fujitsu fi-5530C - Document Scanner 설치 절차

{카테고리_이름} Fujitsu fi-5530C - Document Scanner에 대한 설치 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu fi-5530C - Document Scanner 3 페이지. Color departmental scanner
Fujitsu fi-5530C - Document Scanner에 대해서도 마찬가지입니다: 시작하기 (28 페이지), 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 시작하기 (28 페이지), 브로셔 및 사양 (2 페이지), 사양 (2 페이지), 소모품 교체 및 청소 지침 (14 페이지), 청소 지침 매뉴얼 (13 페이지), 사용 설명서 (10 페이지)

Fujitsu fi-5530C - Document Scanner 설치 절차
Fujitsu SCSI (650) VRS
If you are installing the following models by means of the Kofax 650 Adrenaline SCSI
controller with/without a GSA-2 then use this document.
M4097D-VRS
Fi-5650C-VRS
If you do not have a 650 controller and are not going to use VRS then use the SCSI
scanner installation guide. If you are going to use the optional video interface then use
the video scanner installation guide. If you have an 850S/1700S controller and a GSA-1
interface then you must use the SCSI (GSA-1) VRS scanner installation guide.
Hardware requirements.
You will need a PC system that meets both Fujitsu's and Kofax's recommended
specifications, a Kofax 650 Adrenaline controller and six foot (maximum) Wide SCSI 68-
pin cable. For recommended PC system specifications and SCSI controllers please
reference the
Scanner Hardware Reference
System Disk.
Step A: Installing the VRS drivers.
First boot your PC and install the Kofax VRS driver that shipped with the scanner.
Special note: When installing the VRS driver and any other software that contains
Kofax's Image Controls pay close attention to the individual runtimes. It is strongly
recommended that you install the oldest/lower runtime application first.
Step B: Installing the Adrenaline 650 Adrenaline controller
1. Shut down your PC and remove the case cover.
2. Locate a free PCI slot and remove the back plate if necessary.
3. Install the SCSI controller in an open PCI slot. Make sure that the card is
seated completely in the slot and secured in the frame.
Warning! Failure to secure the SCSI controller in the PC can result in damage
to the SCSI card, scanner, and/or your system.
4. Boot your PC without the scanner attached and check for errors. Make sure
that the SCSI controller is listed as a 650 Adrenaline. If no errors proceed to
the next step.
Step C: Unlocking the shipping lock.
If your model scanner does not have a flatbed then proceed to Step D.
Rev052206A
Scanner Installation Procedures
Windows ME\2000\XP
M4099D-VRS
Fi-5750C-VRS
Fi-4860C-VRS
page. You may also need your Operating
Fi-4990C
Page 1 of 3