Brother MFC-J4310DW 빠른 설정 매뉴얼 - 페이지 6

{카테고리_이름} Brother MFC-J4310DW에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J4310DW 47 페이지. Air print guide - spanish
Brother MFC-J4310DW에 대해서도 마찬가지입니다: 매뉴얼 (36 페이지), 매뉴얼 (22 페이지), 제품 안전 매뉴얼 (17 페이지), 매뉴얼 (13 페이지), 매뉴얼 (13 페이지), 제품 안전 매뉴얼 (20 페이지), (스페인어) 웹 연결 매뉴얼 가이드 (38 페이지), (스페인어) 매뉴얼 (24 페이지), (영어) 제품 안전 가이드 매뉴얼 (16 페이지), (스페인어) 매뉴얼 (12 페이지), (스페인어) 매뉴얼 (11 페이지)

Remove the orange protective part a.

NOTE

Do not throw away the orange protective part.

You will need it if you transport the machine.

Unpack the ink cartridge.

Turn the green release lever on the orange

protective packing a counterclockwise until it

clicks to release the vacuum seal. Then

remove the orange protective packing a as

shown.

IMPORTANT

• DO NOT shake the ink cartridges. If ink stains

your skin or clothing, wash with soap or

detergent at once.

• DO NOT touch the cartridge in the area

indicated b, as this can cause the machine not

to function with the cartridge.

Take care to match the sticker color a with the

cartridge color b as shown in the diagram

below.

Install each ink cartridge in the direction of the

arrow on the label.

Gently push the back of the ink cartridge

marked "PUSH" until it latches. After all the ink

cartridges are installed close the ink cartridge

cover.

NOTE

The machine will prepare the ink tube system for

printing. This process will take approximately four

minutes. Do not turn off the machine.