Brother MFC-J435W 매뉴얼 - 페이지 9

{카테고리_이름} Brother MFC-J435W에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J435W 21 페이지. Product safety guide - spanish
Brother MFC-J435W에 대해서도 마찬가지입니다: 고급 사용자 설명서 (47 페이지), 매뉴얼 (12 페이지), 제품 안전 매뉴얼 (17 페이지), 빠른 설정 매뉴얼 (37 페이지), 안전 매뉴얼 (17 페이지), 빠른 설정 매뉴얼 (37 페이지), (스페인어) 매뉴얼 (21 페이지), (스페인어) 매뉴얼 (16 페이지)

Brother MFC-J435W 매뉴얼
2

Configuring your machine for a network

IP addresses, subnet masks and gateways

To use the machine in a networked TCP/IP environment, you need to configure its IP address and subnet
mask. The IP address you assign to the print server must be on the same logical network as your host
computers. If it is not, you must properly configure the subnet mask and the gateway address.

IP address

An IP address is a series of numbers that identifies each device connected to a network. An IP address
consists of four numbers separated by dots. Each number is between 0 and 255.
Example: In a small network, you would normally change the final number.
• 192.168.1.1
• 192.168.1.2
• 192.168.1.3
How the IP address is assigned to your print server:
If you have a DHCP/BOOTP/RARP server in your network the print server will automatically obtain its IP
address from that server.
Note
On smaller networks, the DHCP server may also be the Router.
For more information on DHCP, BOOTP and RARP, see:
Using DHCP to configure the IP address uu page 14.
Using BOOTP to configure the IP address uu page 15.
Using RARP to configure the IP address uu page 14.
If you do not have a DHCP/BOOTP/RARP server, the Automatic Private IP Addressing (APIPA) protocol will
automatically assign an IP address from the range 169.254.1.0 to 169.254.254.255. For more information on
APIPA, see Using APIPA to configure the IP address uu page 15.
2
2
2
2
2
5