Brother MFC-J4610DW 제품 안전 매뉴얼 - 페이지 14

{카테고리_이름} Brother MFC-J4610DW에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J4610DW 20 페이지. Quick setup guide - spanish
Brother MFC-J4610DW에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (47 페이지), 매뉴얼 (36 페이지), 매뉴얼 (22 페이지), 제품 안전 매뉴얼 (17 페이지), 매뉴얼 (13 페이지), 매뉴얼 (13 페이지), 빠른 설정 매뉴얼 (45 페이지), 빠른 시작 매뉴얼 (29 페이지), 제품 안전 매뉴얼 (25 페이지), 여기에서 시작하기 매뉴얼 (47 페이지), (스페인어) 웹 연결 매뉴얼 가이드 (38 페이지), (스페인어) 매뉴얼 (24 페이지), (영어) 제품 안전 가이드 매뉴얼 (16 페이지), (스페인어) 매뉴얼 (12 페이지), (스페인어) 매뉴얼 (11 페이지), (영어) 빠른 구성 가이드 (47 페이지)

Federal Communications Commission (FCC) Declaration of

Conformity (USA only)

Responsible Party:

declares, that the products

Product Name: MFC-J4310DW/J4410DW/J4510DW/J4610DW/J4710DW

comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.



Consult the dealer or an experienced radio/TV technician for help.



This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.

IMPORTANT

• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the

user's authority to operate the equipment.

• A specific shielded interface cable should be used to ensure compliance with the limits for a

Class B digital device.

Brother International Corporation

200 Crossing Boulevard

Bridgewater, NJ 08807-0911 USA

TEL: (908) 704-1700