Brother MFC490CW - Color Inkjet - All-in-One 연결 매뉴얼 - 페이지 6

{카테고리_이름} Brother MFC490CW - Color Inkjet - All-in-One에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC490CW - Color Inkjet - All-in-One 6 페이지. Mac network connection
Brother MFC490CW - Color Inkjet - All-in-One에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (48 페이지), 빠른 설정 매뉴얼 (47 페이지), 설정 및 설치 (5 페이지), 수리 지침 (2 페이지)

페이지 인쇄

Brother MFC490CW - Color Inkjet - All-in-One 연결 매뉴얼

MFC490CW Vista Network Connection Repair Instructions

b. If the software was previously installed or you already have PaperPort, click on ADVANCED ->

MFL-PRO SUITE WITHOUT PAPERPORT(TM) 11SE. Skip to Step 8.

6. After reading and accepting the ScanSoft PaperPort SE License Agreement, click YES if you agree to

the terms.

7. The installation of PaperPort SE will automatically start and is followed by the installation of MFL-Pro

Suite.

8. When the Brother MFL-Pro Suite Software License Agreement window appears, click YES if you agree

to the Software License Agreement.

9. Choose WIRELESS NETWORK CONNECTION and click NEXT.

10. For Windows Firewall Users: If a firewall is detected, choose CHANGE THE FIREWALL PORT SETTINGS

TO ENABLE NETWORK CONNECTION AND CONTINUE WITH THE INSTALLATION (RECOMMENDED).

Then click NEXT.

11. a. If the Brother machine is the only network-printing device found on the network the installation of

the Brother drivers will automatically start. If there is more than one network-printing device found

you will be asked to select your model machine from the list and then click NEXT.

b. If the Brother machine is not yet configured for use on your network, a window will appear stating:

Find unconfigured Device. Click OK. The Configure IP Address window will appear. Choose SPECIFY

YOUR MACHINE BY ADDRESS (ADVANCED USERS), and enter the IP address information appropriate

to your network, then click NEXT. If you are not certain what information to enter you should contact

your network administrator.

12. The installation screens will appear one after another. Please wait. It will take a few moments for all

the screens to appear. DO NOT try to cancel any of the screens during this installation. If asked:

Would you like to install this device software? Click INSTALL.

13. When the On-Line Registration screen is displayed, click NEXT to continue the installation.

14. When prompted to restart the computer, select YES, I WANT TO RESTART MY COMPUTER NOW, and

click FINISH.

The computer will restart. The installation is now complete. Note: After restarting the

computer you must be logged on with Administrator rights.

15. Attempt to print again.