Brother PE-Design Next 설치 매뉴얼 - 페이지 12

{카테고리_이름} Brother PE-Design Next에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PE-Design Next 16 페이지. Sistema de software de bordado
Brother PE-Design Next에 대해서도 마찬가지입니다: (설치 가이드 (16 페이지)

페이지 인쇄

[STEP2] Upgrading the USB Card Writer Module

(For upgrade customer only)

This section describes how to upgrade the USB card writer module for PE-DESIGN NEXT. Users upgrading

from PE-DESIGN version 5, 6, 7 or 8 must upgrade the card writer. After installing PE-DESIGN NEXT,

immediately follow the procedure below to upgrade the card writer for PE-DESIGN NEXT.

Note:

• In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you

cannot connect to the Internet, contact your authorized dealer or Brother Customer Service.

• It may not be possible to upgrade if a firewall is turned on. Turn off the firewall, and then try

performing the operation again.

Start up Layout & Editing.

→ The dialog box shown below appears.

To begin the upgrade, click Upgrade now.

→ The Upgrade wizard starts up, and the first dialog box shown below appears.

Click Next.

Type in the 15-digit product ID on the label attached to the CD-ROM case, and then click Next.

Note:

• If the product ID is incorrectly entered, the message "The product ID is incorrect. Check that a

mistake was not made during typing." appears.

• The uppercase letters "I" and "O" are not used in the product ID.

• Each product ID is valid for only one USB card writer module.

A product ID that has already been used cannot be used with a different USB card writer module.

Before Use