Fujitsu LifeBook Stylistic Q550 바이오스 매뉴얼 - 페이지 23
{카테고리_이름} Fujitsu LifeBook Stylistic Q550에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu LifeBook Stylistic Q550 23 페이지. Q series
Fujitsu LifeBook Stylistic Q550에 대해서도 마찬가지입니다: 데이터시트 (6 페이지), 시작하기 매뉴얼 (17 페이지), 시작하기 (17 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating through
the Setup Utility on page 2 for more information.)
Info
System
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
F1
Help
ESC
Exit
Table 17: Fields, Options and Defaults for the Exit Menu
Menu Field
Description
Exit Saving
Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory, then exit
the utility. A confirmation message Save Configuration changes and exit now? [Yes][No] is displayed.
Changes
Exit Discarding
Selecting Exit Discarding Changes and Exit will exit the setup utility without writing to the BIOS memory. When the
Changes
BIOS recognizes this selection it will reboot, load the operating system and begin operation.
Load Setup
Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
Defaults
Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.
Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
Discard
previous configuration now? [Yes] [No] will be displayed. When confirmed the setup utility will return to
Changes
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility Section.
Selecting Save Changes will cause the new settings in all menus to be written to the BIOS memory. The message Save
Save Changes
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return to
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility section.
Save Changes
Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the BIOS memory. The
message Save configuration changes and power off now? [Yes] [No] will be displayed. When con-
and Power Off
firmed, the system will shut down. If No is selected, the system will return to the Exit menu. To return to another menu,
follow the directions in the Navigating Through the Setup Utility section.
Phoenix SecureCore(tm) Tiano Setup
Advanced
Security
Select Item
-/+
Change Values
/
Select Menu
Enter
Select ► Sub-Menu
/
Figure 17. Exit Menu
The following table shows the names of the menu fields
for the Exit menu, the default settings and a description
of the field's function and any special information
needed to help understand the field's use.
Boot
Exit
Exit System Setup and
save your changes to
NVRAM.
Shift + 1
Enable or disable(!)
F10
Save and Exit
E x i t M e n u
Item Specific Help
23