Fujitsu P-600 - Stylistic LT 지침 - 페이지 2

{카테고리_이름} Fujitsu P-600 - Stylistic LT에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu P-600 - Stylistic LT 4 페이지. Pen tablet holster
Fujitsu P-600 - Stylistic LT에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지), 사용자 설명서 (8 페이지), 설치 지침 (1 페이지), 사용자 설명서 (2 페이지), 설치 매뉴얼 (4 페이지), 사용자 설명서 (4 페이지)

페이지 인쇄

58-0578-01.fm Page 2 Tuesday, August 21, 2001 2:52 PM

Installation Instructions

An adhesive band secures the screen protector to the

protective strip around the entire perimeter except for

one corner. Hold it up to a light to see which corner does

not have the adhesive strip. (See Figure 1).

1. Peel the protective film from the adhesive side of the

screen protector, as shown in Figure 1.

Adhesive

strip

No Adhesive

Figure 1. Peeling Protective Film

2. Install the screen protector on the pen tablet display

screen. Apply the adhesive side to the screen with the

glueless corner in the lower left, as shown in Figure 2.

3. Apply pressure along the edges of the screen protector

with your finger. (Avoid lifting the screen protector

from the screen after installation. The adhesive requires

48 hours to cure properly.)

Note