Brother DSmobile 620 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Brother DSmobile 620에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DSmobile 620 5 페이지.
Brother DSmobile 620에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (4 페이지), 빠른 설정 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

Federal Communications Commission

(FCC) Declaration of Conformity

(USA only)

Responsible Party: Brother International Corporation

200 Crossing Boulevard

Bridgewater, NJ 08807-0911 USA

TEL: (908) 704-1700

declares, that the products

Product Name: DSmobile 620 / DSmobile 720D

Model Numbers: DS-620 / DS-720D

comply with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.



Call the dealer or an experienced radio/TV technician for help.

IMPORTANT

•

Changes or modifications not expressly approved by Brother

Industries, Ltd. could void the user's authority to operate the

equipment.

•

A shielded interface cable should be used to ensure compliance

with the limits for a Class B digital device.

Industry Canada Compliance Statement

(Canada only)

Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of this device.

L'utilisation de ce dispositif est autorisée seulement aux conditions

suivantes:

(1) il ne doit pas produire de brouillage et (2) l'utilisateur du dispositif doit être

prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est

susceptible de compromettre le fonctionnement du dispositif.