Fujitsu Stylistic LT C-500 설치 지침

{카테고리_이름} Fujitsu Stylistic LT C-500에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Stylistic LT C-500 1 페이지. Screen protector
Fujitsu Stylistic LT C-500에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사용자 지침 (1 페이지), 설치 매뉴얼 (4 페이지), 사용자 설명서 (8 페이지), 설치 지침 (1 페이지), 사용자 설명서 (2 페이지), 설치 매뉴얼 (1 페이지), 지침 (4 페이지), 설치 지침 (1 페이지)

Ferrite Core

Installation Instructions

Stylistic LT C-500

In order to ensure compliance with the pertinent RF

emissions limits governing the Stylistic LT pen tablet,

shielded interconnect cables must be used.

Stylistic LT C-500

Figure 1. Ferrite Core - Open

To meet FCC Class B limits, ferrite cores must be added

to the RJ-11 and the microphone cables when they are

connected to the Stylistic LT C-500. The ferrite core

should be installed adjacent to the end of the cable that

attaches to the system.

8/00

Connector

Cable

To install the core, open it up so that it lies flat (see

Figure 1). Lay the modem or microphone cable into

one of the channels in the open core. The cable should

be positioned so that it is as close as possible to the

connector that enters the pen tablet.

Holding the cable in place, snap the core around the

cable. Figure 2 illustrates the closed ferrite core

without a cable inserted. The illustration may differ

slightly from the ferrite core delivered with your

system.

Be sure to leave the ferrite core in place when the

modem and/or microphone cables are plugged into

the pen tablet.

Figure 2. Ferrite Core - Closed

58-0766-00A