AC Schnitzer G01 M-Technik 피팅 지침 매뉴얼 - 페이지 19

{카테고리_이름} AC Schnitzer G01 M-Technik에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AC Schnitzer G01 M-Technik 20 페이지. Front spoiler elements

Pa in t in g In s t r u c t io n s

Notes on Painting AC Schnitzer Components

Before painting, all AC Schnitzer bodystyling components must be checked for fit on the vehicle (e.g. contact surfac-

es/contours).

Any retouching work (e.g. sanding of contact surfaces/contours) must be carried out before painting !

The quality and durability of the paint on a component depends on the preparation and external influences, and cannot

therefore be compared with that on any other body element.

To avoid distortion/deformation during working and drying, AC Schnitzer components should be placed on a corresponding

jig.

Note !

The painting instructions of the paint manufacturer must be followed !

Painting Steps:

1. Cleaning:

2. Tempering:

3. Inspection:

4. Sanding:

5. Masking off:

6. Cleaning:

7. Filling:

8. Drying:

9. Removal:

10. Sanding:

11. Cleaning:

12. Masking off:

13. Painting:

14. Drying:

AC Schnitzer - automobile Technik - Neuenhofstraße 160 - 52078 Aachen - Tel. 0241/5688 -130

Plastic cleaner / Silicone remover

30 min. at max. 40° C object temperature

Edges and seams on surface (pores etc.), sand down if necessary

2K stopper P220 – P280 (dry), complete component P400 – P600 (dry)

Contact surfaces, TÜV marking, rating plates

Silicone remover

2K HS filler

1 hour at max. 40° C object temperature, component should remain in drying

cabinet overnight

Masking tape on rating plates, contact surfaces and TÜV marking

P800 (dry)

Silicone remover

Contact surfaces

Observe technical data and painting instructions from paint manufacturer

1 hour at max. 40° C object temperature, component should remain in drying

cabinet overnight

Painting Instructions Issue: 01/2010

Fax -135