Fujitsu D2619-N 기술 매뉴얼 - 페이지 34
{카테고리_이름} Fujitsu D2619-N에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu D2619-N 40 페이지. For primergy rx/tx300 s6
페이지 인쇄
Connectors and indicators
LAN connectors
The system board is equipped with an Intel
controller (Intel 82575EB). The LAN controller supports transmission rates of 10
Mbit/s, 100 Mbit/s and 1 Gbit/s.
The LAN controller also supports WOL functionality by means of Magic
Packet™. It is also possible to start a system via a LAN without a separate boot
hard disk drive. PXE is supported here.
The separate service LAN connector is used as a management interface (iRMC
S2) and is prepared for operation with the Remote Management.
Each LAN connector has two LEDs which display the speed of the connection
and its status:
Figure 7: LAN LEDs
No Indicator
1
LAN
link/transfer
(service LAN)
2
LAN speed
(service LAN)
3
LAN
link/transfer
(system LAN)
34
Description
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
Technical Manual
®
dual-port Gigabit Ethernet
D2619-N (RX/TX300 S6)
Features