Fujitsu D2799 기술 매뉴얼 - 페이지 37

{카테고리_이름} Fujitsu D2799에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu D2799 38 페이지. For primergy tx200 s6

Replacing the lithium battery

In order to save the system information permanently and to power the indicator

LEDs E, F, G, H during service (see

provide the CMOS-memory with a current. When the charge is too low or the

battery is empty, a corresponding error message is provided. The lithium battery

must then be replaced.

The lithium battery must be replaced with an identical battery or a battery

type recommended by the manufacturer (CR2450). This information

doesn't apply to the Japanese market.

Do not throw lithium batteries into the trash can. It must be disposed of

in accordance with local regulations concerning special waste.

Make sure that you insert the battery the right way round. The plus pole

must be on the top!

Figure 10: Replacing the lithium battery

Ê Press the locking spring into direction of the arrow (1), so that the lithium

battery jumps out of its socket.

Ê Remove the battery (2).

Ê Insert a new lithium battery of the same type into the socket (3) and (4).

D2799 (TX200 S6)

figure

Technical Manual

6), a lithium battery is installed to