Fujitsu F2MC-16FX QFP-100P 사용자 설명서 - 페이지 9

{카테고리_이름} Fujitsu F2MC-16FX QFP-100P에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu F2MC-16FX QFP-100P 34 페이지. For dsu-fr emulator
Fujitsu F2MC-16FX QFP-100P에 대해서도 마찬가지입니다: 운영 매뉴얼 (14 페이지)

페이지 인쇄

2 Installation

Carefully remove the board from the shipping carton.

First, check if there are any damages before powering up the evaluation board.

For the power supply a DC input voltage of 9V – 12V is recommended. The positive

voltage (+) must be connected to the shield, and ground (GND) must be connected to

the center pin of the connector X12!

Special care must be taken to the maximum input voltage, if the LIN Vs lines are

supplied by the board (JP44/JP45), since the input supply voltage is directly applied

to pin 1 of X6 / X8 without a voltage regulator.

After power-on, the yellow power-on LED's (D16, D17, D18) should be lit. If the LED's do not

light up, switch off the power supply and check input polarity and the settings of JP43, JP29

and JP37.

The in-circuit programming allows the user to program own applications into the Flash

memory. The procedures for Flash programming are described in chapter 4.

If the board shall be used as an emulator target board, switch off the power supply and

remove the microcontroller from the socket. Now the probe cable can be mounted on the

socket. Take care of the pin 1 marking on the socket and fasten the probe cable with the

provided screws.

Do not use any other probe cable than MB2198-505 only!

Connect the probe cable to the MB2198-300 emulation Adapter Board. Check all jumper

settings of the evaluation board (especially JP29), the Probe Cable and the Adapter Board.

When turning on the system, be sure to use the following power-up sequence:

1. Power up the emulator main unit (MB2198-01)

2. Power up the adapter board (MB2198-500)

3. Power up the target board (SK-96320-80PMC)

To turn off the system, switch off the components in reverse order, beginning with the target

board.

Please refer to the corresponding user manuals and application notes for the emulator how

to set up the emulator system. After power on, the 'Reset'-LED (D14) the emulator must be

off and the 'Vcc'-LED must be on.

If the Reset LED is still lit, check the DIP-switch settings of the emulator system and the

power supply of the evaluation board.

Note:

Some customers experience connectivity problems when connecting the MCU into

the socket adapter. Only the small red screwdriver available in your box should be

used to connect the cover (HQPACK) onto the socket (NQPACK).

If the four screws are not tightening equally, then it may cause a poor contact.

Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems

then please loosen the screws and tighten again the screws equally.

Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will

contaminate inside of connector.

SK-96320-80PMC User Guide

Chapter 2 Installation

- 9 -

FMEMCU-UG-960010-12