Fujitsu Mainboard D2974 짧은 설명 - 페이지 24

{카테고리_이름} Fujitsu Mainboard D2974에 대한 짧은 설명을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Mainboard D2974 26 페이지.

6 - English

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://ts.fujitsu.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
The system accepts 2.5 V memory modules with or without ECC.
DDR3 memory modules must comply with the PC3-8500 or PC3-10600 specification.
If you use more than one memory module, then make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
From a memory configuration of 4 GBytes upwards, the visible and usable
main memory may be reduced to 3.5 GBytes.
More than 4 GBytes of main memory can only be utilised with a
corresponding operating system.
Insert pairs of identical memory modules into the slots with the same colour.
Start with the slot that is furthest from the processor.
Slot to be used
Channel A, slot 1
Channel B, slot 2
Channel A, slot 3
Channel B, slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
20
DDR3 1066 / 1333 MHz unbuffered DIMM modules, 240 pin; 1.5 V;
64 bit, with and without ECC
1 to 16 GByte DDR3
1, 2 or 4 GByte for one module
Channel A
Channel B
Channel A
Channel B
Number of memory modules inserted
1
x
Installing/removing main memory
1
2
3
4
2
3
x
x
x
x
x
Fujitsu Technology Solutions
4
x
x
x
x