Fujitsu MB91460 SERIES 애플리케이션 노트 - 페이지 14

{카테고리_이름} Fujitsu MB91460 SERIES에 대한 애플리케이션 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu MB91460 SERIES 23 페이지. 32-bit microcontroller
Fujitsu MB91460 SERIES에 대해서도 마찬가지입니다: 사용자 설명서 (45 페이지), 시작하기 (41 페이지), 애플리케이션 노트 (26 페이지), 애플리케이션 노트 (29 페이지), 애플리케이션 노트 (29 페이지)

페이지 인쇄

After Flash programming you can disconnect the serial cable and change the settings back

to:

Table 6: Jumper and switches on SK91461 Flash Emulation

Before starting debug session, you have to edit the procedure file

PRC\Emu_FLASH_after_load.prc and set correct name of your generated abs-file.

# Emu_Flash_after_load.prc

# ========================

# 2006-04-24

V1.0 MVo

printf "\nprocedure file : Emu_Flash_after_load.prc\n"

printf "\n*********************************************************"

printf "\n*

MB91461 Standalone Emulation with external FLASH

printf "\n*

printf "\n*********************************************************\n"

printf "\nAttention:"

printf "\nPlease use PC-Writer software to program adequeate mhx file"

printf "\n(e.g. STANDALONE\\ABS\\91460_template_91461r.mhx) to external

Flash memory!"

RESET

printf "\n\n-------------------------"

printf "\nload debug information for project programmed to Flash\n"

LOAD/DEBUG STANDALONE\ABS\91460_template_91461r.abs

You have to care that the programmed mhx-file as well as the debug information taken from

MCU-AN-300029-E-V1

MB91461 Emulation

Chapter 3 Evaluation system with MB91461R

Name (Switches)

RES

P15_3

P15_2

INT0

MD0

MD1

MD2

MD3

Name (Jumpers)

P21_0

P21_1

P15_3

P15_2

Attention:

the abs-file originate from the same project!

- 14 -

Setting

ICE

Don't care

Setting

Don't care