Fujitsu MB91460 SERIES 애플리케이션 노트 - 페이지 17
{카테고리_이름} Fujitsu MB91460 SERIES에 대한 애플리케이션 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu MB91460 SERIES 23 페이지. 32-bit microcontroller
Fujitsu MB91460 SERIES에 대해서도 마찬가지입니다: 사용자 설명서 (45 페이지), 시작하기 (41 페이지), 애플리케이션 노트 (26 페이지), 애플리케이션 노트 (29 페이지), 애플리케이션 노트 (29 페이지)
페이지 인쇄
Before starting debug session, please check the settings on starterkit:
Table 8: Jumper and switches on SK91461 for SWB Monitor Debugger
To start debug session connect UART0 via crossed serial cable to your PC's COM port and
double-click the appropriate debug configuration (Mondeb_57K6_COM1/COM2.sup).
A procedure file is executed to run through the startup file of the user project without
overwriting important settings like internal clocks or chip select settings. Procedure file stops
at main()-function.
You can start debugging step-by-step or run up to a breakpoint. Do not use the 'Stop
Execution' button in Softune Workbench! Set INT0 switch on starterkit to L to stop program
execution. Take care to connect switch INT0 to MCU by closing jumper at pin header P24_0!
See also application Note "MB91460 SWB Monitor Debugger" (mcu-an-300028-e-
mb91460_swb_monitor_debugger) for more information on the monitor debugger features.
© Fujitsu Microelectronics Europe GmbH
MB91461 Emulation
Chapter 4 Softune Workbench Monitor Debugger
Name (Switches)
RES
P15_3
P15_2
INT0
MD0
MD1
MD2
MD3
Name (Jumpers)
P21_0
P21_1
P15_3
P15_2
- 17 -
Setting
BRK
Don't care
Don't care
H
H
L
L
L
Setting
Connection
Connection
Don't care
Don't care
MCU-AN-300029-E-V1