Fujitsu PRIMERGY TX100 S1 기술 매뉴얼 - 페이지 17
{카테고리_이름} Fujitsu PRIMERGY TX100 S1에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX100 S1 32 페이지. For tx100 s1
Fujitsu PRIMERGY TX100 S1에 대해서도 마찬가지입니다: 사양 (13 페이지), 서비스 보충 설명서 (46 페이지), 옵션 매뉴얼 (46 페이지)
페이지 인쇄
Features
PCI IRQ Line x - Assignment of the PCI interrupts
PCI IRQ Line x defines which ISA interrupts are used for the separate PCI slots.
If you select Auto in the BIOS setup, the interrupts are assigned automatically
and no further settings are required.
Multifunctional PCI boards or boards with an integrated PCI-to-PCI bridge can
use several PCI interrupts (INTA#, INTB#, INTC#, INTD#). Mono functional PCI
boards (default) only use one PCI interrupt (INTA#) per PCI slot.
The PCI interrupts INTA#, INTB#, INTC# and INTD# are available for each PCI
slot.
The same interrupt can be assigned simultaneously to several PCI boards. You
should avoid this condition due to reduced performance.
If you use a setting other than Auto, the Plug&Play functionality of the system
BIOS for the corresponding PCI boards is deactivated.
Auto
The PCI interrupts are assigned automatically in accordance with
the Plug&Play guidelines.
No ISA interrupt is assigned to the PCI interrupt.
Disabled
3, 4, 5, 6, 7, 9, 10, 11, 12, 14, 15
The selected ISA interrupt is assigned to the PCI interrupt. You
may not select an ISA interrupt that is used by a component on
the system board (e.g. controller) or an ISA board.
D2679-B11 (TX100 S1)
Technical Manual
PCI slots
17